Marshall parameters for quality control of hot mix asphalt after pavement construction

Authors

  • Jaime Bojorque Iñeguez 
  • Cristian Flores
  • Mario V´ásquez

DOI:

https://doi.org/10.7764/RDLC.18.1.178

Keywords:

Hot mix asphalt, Quality control, Pavement construction, Marshall test, Stability and flow

Abstract

Highways have been and are built using Hot Mix Asphalt (HMA) as surface layer. The most common HMA design procedure is the Marshall Method, a method also used for quality control (QC) at the time of road construction. Due to several factors, sometimes it is not possible to sample the surface layer when constructed. When this occurs, QC is performed after construction by analyzing cores. Current regulations, however, fail having clear procedures regarding the collection and analysis of pavement cores after the complete placement of the asphalt mixture. For this reason, this study proposes a comparative analysis of Marshall parameters, mixture densities, and aggregates gradation obtained from specimens obtained during construction, versus cores samples extracted 30 and 60 days later. The research revealed that all the parameters measured on core samples, except flow, could be used to approve asphalt paving works after its construction.

Downloads

Download data is not yet available.

Author Biographies

Jaime Bojorque Iñeguez 

Civil Engineering Department, Faculty of Civil Engineering, University of Cuenca
Av. 12 de Abril s/n, Cuenca (Ecuador)

Cristian Flores

Independent Consulting Engineer
Calle Guayas 6-143, Cuenca (Ecuador)

Mario V´ásquez

Independent Consulting Engineer

Calle Larga 6-13, Cuenca (Ecuador)

Downloads

Published

2019-04-06

How to Cite

Bojorque Iñeguez , J., Flores, C., & V´ásquez, M. (2019). Marshall parameters for quality control of hot mix asphalt after pavement construction. Revista De La Construcción. Journal of Construction, 18(1), 178–185. https://doi.org/10.7764/RDLC.18.1.178