This is an outdated version published on 2022-08-31. Read the most recent version.

Effect of compression casting technique on the water absorption properties of concrete made using 100% recycled aggregates

Authors

  • Rashid Hameed Department of Civil Engineering, University of Engineering and Technology Lahore, Lahore (Pakistan)
  • Zaib-Un-Nisa
  • Muhammad Rizwan Riaz Department of Civil Engineering, University of Engineering and Technology Lahore, Lahore (Pakistan)
  • Syed Asad Ali Gillani Department of Civil Engineering, University of Engineering and Technology Lahore, Lahore (Pakistan)

DOI:

https://doi.org/10.7764/RDLC.21.2.387

Keywords:

Concrete; recycled aggregates; casting technique; sorptivity; durability

Abstract

Effect of compression casting technique on the water absorption characteristics of low grade 100% Recycled Aggregate Concrete (RAC) of target strength range 11 to 15 MPa to be used in the manufacturing of masonry units is investigated. Water absorption characteristics were determined by performing sorptivity test. Recycled aggregates were produced by crushing laboratory-tested concrete samples of strength ranging from 21 MPa to 28 MPa. Two different ratios of recycled coarse aggregate and recycled fine aggregates were investigated using two different cement contents. For comparison, natural aggregate concrete mixes were also tested. The study parameter included effect of aggregates type, casting pressure, casting technique and cement content on the water absorption properties of RAC. Further, depth of penetration of salt was observed using silver nitrate solution after 3-month immersion in 10% NaCl solution. The results of sorptivity test showed positive impact of compression casting technique on water absorption properties of low grade 100% RAC. Further, results showed that RAC mixes exhibited inferior water absorption properties compared to natural aggregates concrete mixes. Various equations were proposed to predict water absorption of 100% RAC under different conditions of casting pressure and cement content based on initial and secondary rate of water absorption.

Downloads

Download data is not yet available.

References

ASTM C127-15, 2015. Standard Test Method for Relative Density (Specific Gravity) and Absorption of Coarse Aggregate, ASTM Internation-al, West Conshohocken, PA.

ASTM C128-15, 2015. Standard Test Method for Relative Density (Specific Gravity) and Absorption of Fine Aggregate, ASTM International, West Conshohocken, PA.

ASTM C131-06, 2006. Standard Test Method for Resistance to Degradation of Small-Size Coarse Aggregate by Abrasion and Impact in the Los Angeles Machine, ASTM International, West Conshohocken, PA.

ASTM C1585-20, 2020. Standard Test Method for Measurement of Rate of Absorption of Water by Hydraulic-Cement Concretes, ASTM International, West Conshohocken, PA.

ASTM C29/C29M-17a, 2017. Standard Test Method for Bulk Density (“Unit Weight”) and Voids in Aggregate, ASTM International, West Conshohocken, PA.

ASTM C33-18, 2018. Standard Specification for Concrete Aggregates, ASTM International, West Conshohocken, PA.

ASTM C566-19, 2019. Standard Test Method for Total Evaporable Moisture Content of Aggregate by Drying, ASTM International, West Conshohocken, PA.

British Standard Institution. BS 812, (2021). Methods for Sampling and Testing of Mineral Aggregates, Sands and Fillers. British Standard Institution, London.

Claudio, J. Z., Ángel, A. D. M., (2011). Use of recycled fine aggregate in concretes with durable requirements, Waste Management. 31 (11), 2336-2340.

Corinaldesi, V., & Moriconi, G., (2009). Influence of mineral additions on the performance of 100% recycled aggregate concrete. Construction and Building Materials. 23 (8), 2869-2876.

Eckert, M and Oliveira, M. (2017). Mitigation of the negative effects of recycled aggregate water absorption in concrete technology. Construc-tion and Building Materials. 133, 416-424.

Guo, H., Shi, C., Guan, X., Zhu, J., Ding, Y., Ling, T.C., Zhang, H., Wang, Y., (2018). Durability of recycled aggregate concrete – A review. Cement and Concrete Composites. 89, 251-259.

ISO, (2016). Business Plan. ISO/TC 71 Concrete, Reinforced Concrete and Prestressed Concrete.

Jagan, S., Neelakantan, T.R., Sarvanakumar, P. (2021). Mechanical properties of recycled aggregate concrete surface treated by variation in mixing approaches. Revista de la Construcción. Journal of Construction, 20, 236-248. DOI: 10.7764/RDLC.20.2.35

Kubissa, W., Jaskulski, R., (2013). Measuring and time variability of the sorptivity of concrete, Procedia Engineering. 57, 634-641.

Kubissa, W., (2016). Sorptivity of concrete. Warsaw University of Technology Publishing House.

Kazmi, S.M.S., Munir, M.J., Wu, Y-F., (2021). Application of waste tire rubber and recycled aggregates in concrete products: A new compres-sion casting approach. Resources, Conservation & Recycling. 167, 105353.

Liang, Z., Hu, Z., Zhou, Y., Wu, Y., Zhou, X., Hu, B., Guo, M., (2022). Improving recycled aggregate concrete by compression casting and nano-silica. Nanotechnology Reviews. 11, 1273-1290.

Nedeljkovic, M., Visser, J., Savija, B., Valcke, S., Schlangen, E., (2021). Use of fine recycled concrete aggregates in concrete: A critical review. Journal of Building Engineering. 38, 102196.

Paktiawal, A., Alam, M., (2022). Experimental evaluation of sorptivity for high strength concrete reinforced with zirconia rich glass fiber and basalt fiber, Materials Today: Proceedings. 49 (5), 1132-1140.

Pedro, D. & Brito, J., Evangelista, L., (2018). Durability performance of high-performance concrete made with recycled aggregates, fly ash and densified silica fume. Cement and Concrete Composites. 93.

Sakai, Y., Tarekegne, B., Kishi, T., (2016). Recycling of hardened Cementitious Material by Pressure & Control of Volumetric Changes. Jour-nal of Advanced Concrete Technology. 14, 47-54.

Tahar, Z., Ngo, T., Kadri, E. H., Bouvet, A., Debieb, F., Aggoun, S., (2017). Effect of cement and admixture on the utilization of recycled aggregates in concrete. Construction and Building Materials. 149, 91-102.

Tam, V. W.Y., Soomro, M., Evangelista, A. C. J., (2018). A review of recycled aggregate in concrete applications (2000–2017). Construction and Building Materials. 172, 272–292.

Tayeh, B. A., Doha, M. A., Alyousef, R., (2020). The Utilization of Recycled Aggregate in High Performance Concrete: A Review, Journal of Materials Research and Technology. 9 (4), 8469-8481.

Thomas, J., Thaickavil, N.N., Wilson, P.M., (2018). Strength and durability of concrete containing recycled concrete aggregates. Journal of Building Engineering. 19, 349-365.

Upshaw, M., Cai, C. S., (2020). Critical Review of Recycled Aggregate Concrete. Properties, Improvements, and Numerical Models. Journal of Materials in Civil Engineering. 32 (11), 03120005.

Wei, R., Sakai, Y., (2021). Experimental investigation on bending strength of compacted plastic-concrete, Resources, Conservation and Recy-cling 169, 105521,

Xiao, J. Z., Li, W. G., Poon, C. S., (2012). Recent studies on mechanical properties of recycled aggregate concrete in China—A review. Science China Technological Science. 55, 1463-1480.

Xinyi, W., Chee, S. C., Jun, X., (2019). Material Characterization for Sustainable Concrete Paving Blocks. Applied Sciences. 9, 1197.

Yehia, S., Helal, K., Abusharkh, A. et al., (2015) Strength and Durability Evaluation of Recycled Aggregate Concrete. International Journal of Concrete Structures and Materials. 9, 219–239.

Downloads

Published

2022-08-31

Versions

How to Cite

Hameed, R., Zaib-Un-Nisa, Rizwan Riaz , M. ., & Ali Gillani, S. A. . (2022). Effect of compression casting technique on the water absorption properties of concrete made using 100% recycled aggregates . Revista De La Construcción. Journal of Construction, 21(2), 387–407. https://doi.org/10.7764/RDLC.21.2.387